The cleaning tool head is slotted so as to hold the cleaning felts and cotton rolls. To insert the felt or cotton roll, back out the set screw, insert felt or cotton roll (centering in slot) and tighten set screw until it is no longer protruding from the tool head.

Flash-hole deburring is a one time operation that should be completed prior to loading new brass. This tool can also be used on fired cases that have not yet been flash-hole deburred.

There are very few differences between loads for long-range target shooting and hunting. When I work up a load for either, I look for a lot of the same things, including accuracy and uniform velocity for on-target hits.

Now that you’ve selected the best cases, deburred the flash holes and uniformed the primer pockets, it’s time for the last step of case preparation – trimming. Trimming your previously- fired cases to proper length is a step that must be done carefully, especially when you are trying to make the most accurate, consistent loads possible.

July was a hot month for us. Not only were the temperatures high, but we found ourselves constantly on the go, with many events and shooting matches on our calendar.

In 2012, Mark Mckee started a 1,000-yard match with its own unique course of fire.

You’ve selected the best brass you can find, and have deburred the flash holes. There’s one more step to complete before loading the cases – primer pocket uniforming.

It’s finally that time of year when the shooting really heats up along with the temperatures.

This instructional video demonstrates how to set up your Swarovski Ballistic Turret on the Swarovski Z3, Z5, Z6 and Z6I Riflescopes.

This instructional video demonstrates how fast and easy it is to apply Markron Custom Bullet and Primer Sealer from Roboco Laboratories.

This instructional video demonstrates how fast and easy it is to apply Markron Custom Bullet and Primer Sealer from Roboco Laboratories.

This manufacturer provided video showcases the El Range Rangefinders from Swarovski.