Sinclair developed this handy steel adapter so you could use Sinclair Primer Pocket Uniformers in you Lyman, Hornady, or RCBS powered case prep center.
Your new Sinclair Competition Shooting Rest will provide you with years of reliable service. Please read the following instructions as your new rest require some final assembly prior to use.
The cleaning tool head is slotted so as to hold the cleaning felts and cotton rolls. To insert the felt or cotton roll, back out the set screw, insert felt or cotton roll (centering in slot) and tighten set screw until it is no longer protruding from the tool head.
Flash-hole deburring is a one time operation that should be completed prior to loading new brass. This tool can also be used on fired cases that have not yet been flash-hole deburred.
There are very few differences between loads for long-range target shooting and hunting. When I work up a load for either, I look for a lot of the same things, including accuracy and uniform velocity for on-target hits.
Now that you’ve selected the best cases, deburred the flash holes and uniformed the primer pockets, it’s time for the last step of case preparation – trimming. Trimming your previously- fired cases to proper length is a step that must be done carefully, especially when you are trying to make the most accurate, consistent loads possible.
This instructional video demonstrates how to set up your Swarovski Ballistic Turret on the Swarovski Z3, Z5, Z6 and Z6I Riflescopes.
This instructional video demonstrates how fast and easy it is to apply Markron Custom Bullet and Primer Sealer from Roboco Laboratories.
I know the current thinking is to build “Across the Course” rifles on an AR frame (space gun) or something along the lines of a Tubb rifle but I have always enjoyed shooting a bolt gun.
After firing your brass, the first task is to clean the cartridges. Residue from firing collects on the outside of the case. Some residue may be present along the body but most of it is concentrated in the neck and shoulder area.
I started varmint shooting close to 50 years ago and just recently got hooked on F-Class competition within the last few years.
I sometimes talk to shooters about “across the course” shooting and I take for granted that everybody know what this type of shooting is.
Thank you for contacting our Chat Team! Please visit us again.
If you would like a copy of the chat transcript please click "Send Transcript" below.
Hello, to begin a chat session with a customer service representative, complete the fields below and click Chat